2020427&ensp·&enspBall mill is suitable to grind various mineral and other materials, which is widely used in various industries such as benefication, construction materials, chemical industry, etc, it has two ore grinding ways: dry way and wet way. According to discharge type of finished powder, it can be divided into two kinds: grid type and overflow type.

2020518&ensp·&enspThe basic parameters used in ball mill design (power calculations), rod mill or any tumbling mill sizing are material to be ground, characteristics, Bond Work Index, bulk density, specific density, desired mill tonnage capacity DTPH, operating % solids or pulp density, feed size as F80 and maximum chunk size, product size as P80 and maximum and finally the type of circuit open/closed

Figure 5. Highlow wave ball mill liner Materials The selection of the material of construction is a function of the application, abrasivity of ore, size of mill, corrosion environment, size of balls, mill speed, etc. liner design and material of construction are integral and cannot be chosen in isolation.

201784&ensp·&enspSince for the ball mill design we are using 80% passing, the required value of C2 for the ball mill will be equal to1.20. C3 is the correction factor for mill diameter and is given as 𝐶𝐶3 = 2.44 𝐷𝐷 0.2 (3) However, it is important to note that C3 =0.914 vessel used in producing the ball mill was got from a

Design, Construction and Performance Analysis of a 5 Kg Laboratory Ball Mill. Since for the ball mill design we are using 80% passing, the required value of C2 for the ball mill will be equal to1.20. C3 is the correction factor for mill diameter and is given as

2020517&ensp·&enspA ball mill, a type of grinder, is a cylindrical device used in grinding (or mixing) materials like ores, chemicals, ceramic raw materials and paints.Ball mills rotate around a horizontal axis, partially filled with the material to be ground plus the grinding medium. Different materials are used as media, including ceramic balls, flint pebbles and stainless steel balls.

2020523&ensp·&enspType CHRK is designed for primary autogenous grinding, where the large feed opening requires a hydrostatic trunnion shoe bearing. Small and batch grinding mills, with a diameter of 700 mm and more, are available. These mills are of a special design and described on special request by all Ball Mill Manufacturers. Types of Grinding Mill Manufactured.